Engineering Quad · 1/10" on Tabloid · Portrait

Decimal-inch quad with 1/10" cells and bold 1" reference lines.

Cross-Section Tabloid · ANSI B Portrait 2.54 mm spacing
Sheet
Tabloid
Standard
ANSI B
Dimensions
279 × 432 mm
Orientation
Portrait
Cell pitch
2.54 mm

About this template

A North American decimal-inch grid: 1/10" (2.54 mm) cells with every tenth line emphasised to give a clean 1" reference rhythm. The format originated in mechanical engineering offices that worked in decimal inches rather than fractional inches. See also: A short reading list on technical drawing standards can help you put any of these grids in their historical and standards-based context.

Best used for

  • Decimal-inch mechanical layouts
  • Lab plots in disciplines that work in inches
  • Survey and earthworks calculations
  • Hand calculations for civil-engineering coursework

Why Tabloid in portrait

11×17" / "Ledger" - the ANSI B counterpart to A3 for studios on US paper stock. Almost every office multi-function printer accepts it. The portrait orientation gives you 279 mm of horizontal run and 432 mm of vertical, which suits tall subjects - elevations, sections, single-column drawings - where the eye reads top-to-bottom. Trim and bleed allowances on consumer printers will normally remove a 5 mm strip from each edge; this grid is generated to remain measurable even after that trim, with no critical content placed inside the printer-margin band.

Standards and lineage

Format matches the National Engineering Quad No. 17 specification used by U.S. engineering schools. The Tabloid sheet itself follows ANSI B, and the title-block conventions assumed by this template come from ISO 5457:1999 - the international standard governing how technical drawings are framed, dated, and signed. Background reading: See our scale-and-projection guides for a deeper dive on how all the standards in this lineage interact in practice.

A short history of this grid

Engineering quad paper was a standard issue in U.S. engineering schools from the 1950s onward; pads of green-printed quad paper remain on the desk of virtually every working civil engineer.

Printing notes

For accurate output, print at 100 % scale - never "fit to page", which silently shrinks the sheet by 4–6 % and breaks every measured cell. Use a laser printer if the grid will be traced over with ink, since inkjet inks bleed through technical pen and pencil. If your printer cannot handle the full Tabloid sheet, scale the SVG to the next-smaller paper size before printing - every GridCraft grid is delivered as vector artwork so it scales cleanly. The downloaded SVG carries the physical sheet dimensions in millimetres, so a compliant print driver should print at 1:1 by default. Our how-to-print guide walks through the calibration test in 30 seconds.

Designer's note

Specialty grids reward the discipline of choosing the right sheet for the right drawing. A Engineering Quad · 1/10" on Tabloid is not a one-size-fits-all sheet - it's a calibrated tool for a specific class of problem. Use it where the page suits the drawing; reach for a different sheet when it doesn't. The catalogue is large precisely so you don't have to compromise on the projection, scale or sheet size.

Related templates